Serving the Raleigh area  ·  (984) 733-0998  ·  Open Mon-Sun 7am-7pm
📞 (984) 733-0998 Free Quote

Metal Roofing in Morrisville, NC (27560) · Local Professionals

Raleigh Metal Roofing · Fast response in Morrisville and the Raleigh area · Free estimate 24h

✅ Metal Roofing Alliance Member 🛡️ Licensed & Insured 💸 Free Quote 24h 🕐 Mon-Sun 7am-7pm
+12Verified Reviews
17Years in Business
4.9 ★Google Rating
24/7Available
✅ No hidden fees💳 Cards accepted🛡️ Licensed & Insured✅ Metal Roofing Alliance Member

Morrisville sits right on top of Research Triangle Park, and its housing stock shows it: 1990s and 2000s two-story brick and vinyl-sided homes off Morrisville-Carpenter Road and around Church Street, plus newer builds near Park West Village and the 540 interchange. Most lots are small and tight, which changes how you stage a reroof.

Homeowners in 27560 call Raleigh Metal Roofing when their original shingle roof hits the end of its life and they want something that handles wind and summer storms without constant patching. We have been working out of Raleigh since 2009, and we know the drive down I-40 to Morrisville well.

Metal Roofing in Morrisville (27560)

Morrisville is mostly flat to gently rolling ground, and the newer subdivisions near RTP pack homes close together with narrow side yards and shared drainage swales. That means panel delivery and staging have to be planned around driveways and HOA rules, not just the roof itself. Many of these homes have low-slope porch sections and complex roof lines with valleys, so flashing and seam layout matter more than they would on a simple gable. The tall loblolly pines that shade a lot of these lots are beautiful until an ice storm or a summer thunderstorm drops a limb, and black algae streaks are common on the shaded north-facing shingle roofs here.

We have been serving Morrisville and the greater Raleigh area since 2009, and our crews are fully insured with general liability and workers' compensation. We handle the retrofit over existing shingles where code allows it, and we install gutters sized for metal roofs so runoff from a heavy afternoon storm does not end up against your foundation.

Our services in Morrisville

How a Job Works in Morrisville

Step 1: you call (984) 733-0998, and we set up a free on-site assessment. We look at the existing roof layers, deck condition, flashing, and attic ventilation, then give you a written estimate with the panel options that fit your home and your HOA.

Step 2: we pull the required roofing permit through the local building department and coordinate with your HOA if design review is needed. On tight Morrisville lots we stage materials in the driveway and keep the crew on one side of the house at a time, and we protect landscaping and AC units before tear-off starts.

Step 3: cleanup and a final walkthrough. We magnet-sweep the yard and driveway for nails, haul away all debris, and walk the roof and gutters with you so you can see the finished seams, flashing, and fasteners before we call the job done.

Pricing in Morrisville depends on roof size, pitch, how many layers are coming off, and whether the deck needs repair. As a ballpark, metal roof installation starts at $8 per square foot, standing seam at $10, metal roof replacement at $9, and a retrofit over existing shingles at $7. Repairs and leak calls start at $450, screw replacement and re-fastening at $750, and flashing or chimney work at $600. Gutters for metal roofs start at $9 per linear foot, and coating or painting starts at $2.50 per square foot. Urgency matters too, since an active leak during a storm window costs more to stop than a planned replacement. Call (984) 733-0998 for a free estimate on your specific roof.

✅ Metal Roofing Alliance Member, licensed and insured for work in Morrisville and nearby areas.

My 1990s home near Park West Village has its original shingle roof. Can you install metal over it?
Often yes, if your roof has only one layer of shingles and the deck is sound. Wake County code limits how many existing layers you can recover over, and we check that during the free assessment. If a tear-off is required, we tell you up front and price it clearly.
A storm just peeled back panels on my roof in Morrisville. How fast can you get out?
We treat wind-lifted panels and active leaks as priority calls. Call (984) 733-0998 and we will schedule an inspection, usually within a day or two depending on storm volume across Wake County. We document the damage with photos for your insurance claim, though coverage decisions are always up to your insurer.
What does a typical metal roof replacement cost for a two-story home in 27560?
Most Morrisville two-story homes land in a range based on square footage and panel choice. Installation starts at $8 per square foot and standing seam at $10, so a 2,000 square foot roof is roughly $16,000 to $20,000 before extras like deck repair or gutters. We give you a firm number after the on-site assessment.
Do I need a permit for a metal roof in Morrisville, and who handles it?
A full replacement or re-roof generally requires a permit, and thresholds and inspection requirements vary by jurisdiction. We pull the permit for you and schedule the inspections. For the current rules, check the City of Morrisville website or call the local building department, since requirements can change.
My HOA has design rules. Can you help with approval before we order panels?
Yes. Many Morrisville subdivisions restrict panel profile and color, so we review your HOA guidelines before ordering and provide the product specs and color samples your board usually asks for. On property lines, we keep panels and gutter runoff on your side and follow setback rules for any work near a neighbor.
Are your crews covered by insurance while working on my property?
Yes. We are fully insured with general liability and workers' compensation, and we can provide a certificate of insurance before work starts. That protects you if anything goes wrong on your property during the job.
What maintenance does a metal roof need in Morrisville's climate?
Check fasteners and seam edges once a year, especially after ice storms or heavy summer thunderstorms, and keep pine needles and leaves out of valleys and gutters. A coating refresh every several years helps on older panels. We offer free inspections and can re-fasten loose screws before a small issue becomes a leak.
Why choose us?

Trusted professionals since 2009

🏅

Licensed contractors

Continuous training, professional equipment, meticulous and code-compliant work

🛡️

Licensed & Insured

Full coverage on all our job sites, no exceptions

⚡

Available Mon-Sun 7am-7pm

Emergencies, weekends, holidays: available when you need us

💰

100% Free Quote

Response within 24h, no commitment, by phone or form

Our services

Our Metal Roofing Services in Raleigh

All your work handled by qualified professionals in Raleigh

Metal Roof Installation

Complete metal roof systems engineered for your local climate and built to outlast three shingle roofs.

Included in your service

  • Deck inspection and repair before any panel goes on
  • High-temp synthetic underlayment and correct ridge and soffit ventilation
  • Manufacturer-certified panel, trim, and flashing details for the full warranty
  • Free on-site assessment and written estimate within 24h
Learn more→

Standing Seam Metal Roofing

Concealed-fastener standing seam: no exposed screws to loosen, leak, or need re-torquing.

Included in your service

  • Panels roll-formed to the exact length of your roof, no end laps
  • Mechanically seamed or snap-lock profiles with concealed clips
  • Floating clip system that lets panels expand and contract freely
  • Kynar 500 / PVDF finish in the full architectural color range
Learn more→

Metal Roof Replacement

Full tear-off of an end-of-life shingle, cedar, or metal roof, replaced with a complete new system.

Included in your service

  • Tear-off and haul-away of the old roofing, dumpster included
  • Decking inspected board by board, rot and soft spots replaced
  • New underlayment, drip edge, valleys, and penetration flashing throughout
  • Documentation of the finished system for your insurer or future buyer
Learn more→

Metal Roof Over Shingles (Retrofit)

Retrofit metal installed over sound existing shingles: no tear-off, less waste, lower cost.

Included in your service

  • Honest deck and shingle assessment first, recover only when it is the right call
  • Furring strips or slip sheet as the panel profile and local code require
  • Existing vents, pipe boots, and flashings reworked to the new roof plane
  • Straight guidance on when tear-off is the better long-term choice
Learn more→

Metal Roof Repair

Targeted repair of damaged, loose, or storm-hit metal roofing before it reaches your ceiling.

Included in your service

  • Bent, dented, or punctured panels replaced and color-matched
  • Seams, laps, and penetrations resealed with compatible butyl and sealant
  • Failed pipe boots, closures, and ridge cap fasteners renewed
  • Written findings with photos of what we found and what we fixed
Learn more→

Metal Roof Leak Repair

Priority leak response: we trace the leak to its real source instead of caulking the symptom.

Included in your service

  • Water testing and interior tracing to find the true entry point
  • Backed-out fasteners, separated seams, and flashing gaps corrected at the cause
  • Emergency tarping available same day after a storm
  • Attic and insulation moisture check so hidden damage does not sit and spread
Learn more→

Screw Replacement & Re-Fastening

The top cause of leaks on 15 to 30 year old screw-down roofs, fixed for a fraction of replacement.

Included in your service

  • Every fastener replaced with oversized screws and new EPDM sealing washers
  • Dried-out washers and stripped holes addressed panel by panel
  • Ridge, eave, and sidewall closures renewed at the same time
  • Restores a watertight roof without replacing sound panels
Learn more→

Corrugated & Ribbed Panel Roofing

Corrugated, tuff-rib, and 5V panel roofing: the budget-friendly workhorse for homes and outbuildings.

Included in your service

  • Galvalume and painted steel panels cut to length on site
  • Correct screw pattern and torque so washers seat without over-driving
  • Foam and metal closures at ridge, eave, and rake to keep weather and pests out
  • Full color range for homes, cabins, barns, and workshops
Learn more→

Metal Shingle Roofing

The look of architectural shingle, slate, or shake with the lifespan and wind rating of steel.

Included in your service

  • Interlocking stamped steel or aluminum shingle panels
  • Walkable finished surface, easier to service than a standing seam field
  • Lightweight enough for retrofit over an existing roof structure
  • Profiles and colors that suit historic and HOA-governed neighborhoods
Learn more→

Stone-Coated Steel Roofing

Steel strength under a textured stone finish, with strong hail and wind performance.

Included in your service

  • Acrylic-bonded stone granule surface over structural steel
  • Battened or direct-to-deck installation depending on the profile
  • Class A fire rating and high impact resistance ratings
  • Tile, shake, and shingle textures for suburban and coastal homes alike
Learn more→

Copper & Specialty Metal Roofing

Copper, zinc, and aluminum for porches, bay windows, dormers, and full architectural roofs.

Included in your service

  • In-house fabrication of pans, valleys, and custom curved details
  • Soldered seams and joints where the detail calls for it
  • Isolation of dissimilar metals to prevent galvanic corrosion
  • A living patina that develops over decades of service
Learn more→

Metal Roof Coating & Painting

Restoration for faded, chalking, or surface-rusted metal, adding 10 to 15 years without replacement.

Included in your service

  • Wash, degrease, and mechanical prep of the entire panel surface
  • Rust treatment and primer on affected areas before topcoat
  • High-performance elastomeric or silicone coating system applied to spec
  • Honest assessment first: we say so when the roof is past coating
Learn more→

Flashing, Chimney & Skylight Repair

Flashing is the number one leak point on any metal roof, and it is what we fabricate best.

Included in your service

  • Custom bent step, counter, and apron flashing made in-house
  • Chimney crickets to shed water on the uphill side
  • Skylight curbs and head flashing rebuilt to the panel profile
  • Valley and wall transition details closed with matching trim
Learn more→

Snow Guards & Ice Protection

Snow retention that stops rooftop avalanches onto decks, gutters, walkways, and entryways.

Included in your service

  • Pad-style guards or continuous rail systems matched to your panel
  • Layout calculated from roof pitch, panel length, and local snow load
  • Clamp-on mounting on standing seam, no panel penetrations
  • Ice dam and eave detailing for higher-elevation homes
Learn more→

Storm & Wind Damage Repair

Wind, hail, and fallen-limb repair with thorough documentation and a straight repair-or-replace answer.

Included in your service

  • Free post-storm inspection with dated photo documentation
  • Emergency tarping and temporary weatherproofing when needed
  • A written report you can use when documenting your insurance claim
  • Honest assessment of repair versus replacement, with no pressure either way
Learn more→

Metal Roof Inspection

A written, no-obligation assessment of fastener condition, seams, flashing, and remaining service life.

Included in your service

  • Fastener, washer, and seam condition checked across the field
  • Flashing, penetrations, and closures inspected point by point
  • Coating wear, chalking, and corrosion graded panel by panel
  • Written report with photos and a straight answer on years remaining
Learn more→

Gutters for Metal Roofs

Gutters sized and hung correctly for metal roofing, where standard hangers and spacing do not work.

Included in your service

  • Seamless aluminum or half-round systems formed on site
  • Hanger placement and spacing matched to the panel profile
  • Oversized capacity and downspouts sized for heavy regional rainfall
  • Bracket spacing tightened for high-wind zones so storms do not tear the gutter off
Learn more→

Commercial & Agricultural Metal Roofing

Barns, workshops, churches, and light commercial metal roofing across the county.

Included in your service

  • Long-run panels for wide spans and low-slope structures
  • Purlin and framing attachment detailed for the building type
  • Insulation, vapor barrier, and condensation control options
  • Repairs and re-fastening for aging agricultural metal buildings
Learn more→
Verified client reviews

12+ Verified Client Reviews in Raleigh

⭐⭐⭐⭐⭐ 4.9/5 · 12 verified Google reviews

Free Quote

Get Your Free Quote

Metal Roofing in Raleigh · Response within 24h · No commitment · ☎ (984) 733-0998

Your Free Quote Request

Confidential · Response within 24h

✅ Free personalized estimate ⚡ Response within 24h 🛡️ Licensed & Insured 📍 On-site visits included in Raleigh ✅ No hidden fees 🕐 Available Mon-Sun 7am-7pm